- : 0086-21-61182423
- : 0086-21-61182425
- : [email protected]
- : Room 301,Unit 6,lane 2500,xiupu Road,Kangqiao Industrial Area,Pudong New District,Shanghai
- API 5CT N80 casing and tubing pipe
- API 5CT K55 casing and tubing pipe
- API 5CT J55 casing and tubing pipe
- EN10028-2 16Mo3 Boiler and Pressure Vessel steel Plate Notch impact energy
- EN10028-2 P265GH Pressure vessels steel equivalents
- EN 10210 S355J2H low alloy carbon structural steel
- EN 10210 S355J0H steel hollow materials
- GB/T 18248 34CrMo4
- GB/T 18248 35CrMo alloy steel
- 30CrMo steel Heat treatment, 30CrMo steel tube/pipe
What is the process of the IMPACTS?
In an impact test, the test specimen is shaped like a rectangle. The term “longitudinal” or “transverse” refers to whether the grain of the steel in the test specimen runs the length of the rectangle (“longitudinal”) or the width of the rectangle (“transverse”). The “notch” goes in the middle of the length of the rectangle on one side. The hit from the pendulum strikes the side of the specimen (against the long side of the rectangle) in the middle of the notch. So in a longitudinal specimen the directional force of the impact from the hit goes across the grain of the specimen. In a transverse specimen the directional force of the impact from the hit goes parallel to the grain of the specimen (or effectively, between the strands of the grain).
When the directional force of the hit goes across the grain (as it does in a “longitudinal” test), it is harder to fracture the specimen than if the force goes parallel to the grain. It takes more energy to break the steel across the grain. That is why a longitudinal specimen has higher notch toughness than a transverse specimen. In other words, it will take more foot pounds (or joules) of absorbed energy to break a longitudinal specimen. When a steel mill is required to produce 20 ft lbs longitudinally, the transverse impact will be less (say 12 ft lbs). It is easier for a steel mill to produce impact (or “notch”) toughness longitudinally because the grain direction of the steel provides a natural resistance to fracture. If you ask the same mill to produce 20 ft lbs transversely instead of longitudinally, it will be more difficult for the mill to do, because the grain of the steel will not be a factor in resisting the fracture.